Alright, so I'm going to show you howto do inside ring engraving using the laser machine. First, you need to get theproper diameters, so inside diameter 19.7, 4.9. So I'll go to the program. Ring 19.7, and 4.9. Hit okay. Now you've got the ring template. We're gonna get the text, Inside Ring Engraver. Select the text, center it. We're gonnaselect Scan, Laser Engraving. Make the gap about 0.1, it should be good. Create. Select Machine, Select Inside Engraving. Now we go to the machine.
Alright,a single batch right here. Take the ring and place it on the single notch. Make sure your machine is on. Okay now if you lookat the program it adjusted to 65millimeters but we're gonna readjust it afterward. So you have an 8 showing, it says 11 degrees on theprogram so we're gonna raise this 11degrees first. At 11 degrees the H is still a littlebit off so I'm gonna raise it up until I see a clear H. That H is thecenter so I'm going to move it to the right little bit right there. So secondI'm gonna measure the height again. We raised the stake here so it's at 69 milliliters so come back to the program. I'm going to hit 69, Apply. Then once I apply, hit Power. 90 percent, 1,000, repeat only once and we're gonna sendthe job. Here we go.